WASHING MACHINE
Owner’s Instructions
WT80S0(P)/WT80S1(P)/WT80S2(P)/WT80S2SG
BEFORE USING THE WASHING MACHINE 1
PRECAUTIONS
CONTROL PANEL
1
1
DESCRIPTION AND CLEANING OF PART 2
WASHING PROCEDURE
To Wash
To Spin Dry
To Rinsing
Overflow rinse
Additional rinse
INSTALLATION
Location
Mounting the legs
Connecting the drain hose
LAUNDRY GUIDE
MAINTENANCE
TROUBLE SHOOTING
3
3
3
3
3
4
4
4
4
4
5
5
5
Before operating the washing machine, please read this manual
thoroughly, and retain it for future reference.
CONTROL PANEL
BEFORE USING THE WASHING MACHINE CAUTIONS
0
•
Remove the cap-hose
from the drain hose.
•
Be sure that the washer is grounded.
To avoid electrical shock,use a
metal pipe for the ground
1.
WASH TIMMER
This is used to set the
wash time, 1-15 minutes.
15
12
3
6
9
connection. But, don't ground the
washer with gas pipes or telephone
lines to avoid to dangers of explosion
or lightning strike.
WASH TIMER
•
In the case of pump drained
washer, remove
the cap-hose from
the drain hole.
2.CYCLE SELECTOR
This is used to set the
Washing/Rinsing
or Draining.
Wash/Rinse
Wash
Drain Rinse
Drain
CYCLE SELECTOR
CYCLE SELECTOR
•
•
Do not put your hands into the
spin dryer basket when it is
spinning.
Your fingers can be caught by
spinning laundry and damaged.
0
3.
SPIN DRY TIMER
5
4
1
2
This is used to set the
spin time, 1-5 minutes.
PRECAUTIONS WHEN OPERATING
3
SPIN DRY TIMER
SELECTOR
4.WATER
•
Don't use excessively hot water.
(50˚C or more)
Plastic parts may be deformed or damaged.
Also, clothing may be deformed or decolored.
Never allow children to operate
or play with the washer.
Children playing with the
washer may accidentally
fall into the washing tub.
During washing, WATER SELECTOR
KNOB should be selected.
During spin rinsing, WATER
SELECTOR KNOB should
be selected.
Wash
Spin
WATER SELECTOR
•
•
Before washing,check all pockets.
If nails or pins remain in pockets,they may
damage the washer or clothes.
•
•
Disconnect the power cord from the
power supply when not in use.
5
SELECTOR
.WASH
Normal
Normal
Heavy Soft
Heavy
Soft
Normal
Close the water tap a little if the
water pressure is too high.
Ventilation opening must not be obstructed
by carpeting when the washing machine is
installed on a carpeted floor.
WASH SELECTOR
WASH SELECTOR
WASH SELECTOR
This is used to select wash action.
You can wash laundry effectively
by various methods.
•
•
Never splash water on the control panel.
•
•
If the supply cord of this appliance is
damaged, it must only be replaced by a repair
shopappointed by the manufacturer, because
special purpose tools are required.
Be sure to cover with the inner
cover on laundry before spinning.
This prevents laundry from
being tossed out and damaged.
Warning to avoid overfilling and damages this
appliance must be filled with the operator
present using a moderate water supply
pressure only.
•
•
To avoid water splashes, close the
wash tub lid.
Be sure laythe drain hose down.
(in case no drain pump)
•
•
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
To avoid overfilling and damages this appliance
must be filled with the operator present using a
moderate water supply pressure only.
1
DESCRIPTION AND /CLEANING OF PARTS
CLEANING THE FILTER
• Pull the overflow filter out and take up
the filter by removing 3 screws as
shown in figure. Wash the filter and
washing tub.
SPIN DRYER LID
When you open this
INNER LID
lid while the spin basket is
spinning,the spinning will
be stopped by the brake
system.
DRAIN HOSE
• Push the strainer(filter) out and take
up the filter as shown in figure.
Wash the filter and washing tub.
SPIN DRYER BASKET
(with pump)
POWER CORD
The plug’s shape
may not be similar to that
shown in this drawing.
OVERFLOW
FILTER
LINT FILTER
This is used for
gathering the
dregs made
DRAIN FILTER
In case of incomplete drain,
disassemble the drain filter with
screw driver(+), and remove
lints from the filter as shown
in the filter as shown in
the figure.
WATER DRAIN HOSE
(without pump)
during washing.
WASH TUB LID
Be sure to keep
the lid closed
EARTH WIRE
WASH TUB
during washing
and spinning.
HOW TO CLEAN THE FILTER
(In case drain pump)
1. Place a rag under the washer filter
not to wet the floor.
PULSATOR
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and
DRAIN FILTER
(with pump)
CLEANING THE LINT FILTER
• If the dregs are piled up in the
lint filter after finishing the wash,
push down and
OVERFLOW FILTER
Pull the upper side of the
overflow filter with
two fingers inserted into
hole ‘A’ in the
OVERFLOW FILTER
• Pull the upper side of the
overflow filter with your
fingers into the holes
in the direction of
rotate the filter
clockwise until it
locks in position.
A
pull it out as
direction of arrow
shown in the
arrow as shown
as shown in the figure.
figure.
in the figure.
• Wash the filter
net in water.
CLEANING THE WASH TUB
First, fill water in the wash tub to ‘L’ level(
operating wash cycle for 1~2 minutes. •Close the wash tub lid.
, then drain water from the wash tub simultaneously with
2
WASHING PROCEDURE
TO WASH
TO SPIN DRY
TO RINSING
1. Before starting to wash, proceed as follows,
Connect the water supply hose and open
the water tap.
1. Transfer the clothes into the
spin basket and arrange the
clothes evenly.
1. Set the cycle selector KNOB to
‘WASH.RINSE’.
Wash/Rinse
Wash
(In the case of
Drain Rinse
Drain
• Lay the drain hose down toward
a sinkhole. (In case no drain pump)
• Place the drain hose in sink or bath.
(In case no drain pump)
drain pump
‘WASH’)
CYCLE SELECTOR
CYCLE SELECTOR
2. Be sure to replace the safety
cover and close the
2. Supply the proper amount of water
so as not to delete one space
overflow the top of the
inner lid
• Connect the power cord to the power
inner lid.
0
9
supply outlet.
safty cover
washing tub.
Normal
15
3
6
Soft
Heavy
2. Set the WASH SELECTOR
KNOB to the desired mode.
12
3. Set the WASH TIMER to
2~3 minutes.
WASH TIMER
WASH SELECTOR
3. Close the spin
dryer lid.
Wash
Spin
3. Set the WTER SELECTOR
KNOB to the desired mode.
4. Drain the water.
Set the delete one space
cycle selector
Drain
WATER SELECTOR
CYCLE SELECTOR
4. Set the CYCLE SELECTOR KNOB to
“WASH.RINSE”.(in case drain pump WASH)
KNOB to ‘DRAIN’.
0
3
4. Set the SPIN DRY
TIMER 1-5 minutes.
5. Repeat this cycle until drain
water is clean. (2~3 cycles)
Wash/Rinse
Wash
5
4
1
2
Drain Rinse
Drain
Rin
OVER FLOW RINSE
SPIN DRY TIMER
CYCLE SELECTOR
CYCLE SELECTOR
1. Keep supplying
Wash/Rinse
Wash
water(adjust water
pressure to ensure
that the amount of
Drain Rinse
Drain
5. Fill water in the wash tub
and add the detergent.
CYCLE SELECTOR
CYCLE SELECTOR
water supplied
does not exceed the amount
of water drained.)
6. Load laundry in the
wash tub and fill water
to proper water level.
0
15
12
3
6
0
2. Set the WASH TIMER
6~8 minutes.
15
12
3
6
7. Set the WASH TIMER
1-15 minutes.
9
WASH TIMER
0
3. As soon as the
WASH TIMER
shuts off, turn off
the water tap.
9
15
3
WASH TIMER
8. After washing, set the CYCLE
SELECTOR KNOB
12
6
Drain
9
to 'DRAIN' for drain.
WASH TIMER
CYCLE SELECTOR
4. Set the CYCLE
SELECTOR KNOB
to ‘DRAIN’.
Drain
CYCLE SELECTOR
3
INSTALLATION
ADDITIONAL RINSE
LOCATION
CONNECTING THE DRAIN HOSE
1 After rinsing you can select this
course for more effective rinse
(Don't just select this course
for rinse.) Load the laundry
evenly into the spin basket.
Leave some space of
at least 15cm between the washing machine
and the wall.
Place the washing machine on a sturdy flat surface.
If the washing machine is placed on an uneven
or weak surface, noise or vibration may occur.
(Allowable is 2˚)
After attaching the connector ring(a), insert the
drain hose(b) in the draining direction.
a
b
2 Set the WATER SELECTOR
KNOB to SPIN and
Never install the washing machine near water.
Do not place the washing machine in steamy CONNECTING THE DRAIN HOSE
Drain
Wash
Spin
CYCLE SELECTOR
KNOB to ‘DRAIN’.
room or where the washing machine is directly 1. Before connecting the drain hose, remove
CYCLE SELECTOR
WATER SELECTOR
exposed to rain.
the cover (a) from the drain hole.
3 Supply water for about 1 minute.
Adjust the water flow to prevent
overflow from the wash tub.
Moisture may damage electrical insulation and 2. After pressing the joint ring (b), insert the
cause an electrical shock to occur.
Avoid direct sunlight or heating devices.
As plastic and electrical components are
affected by direct heat, never place the washing
machine near heaters, boilers, etc., or under direct
sunlight.
drain hose(c) to drain direction.
4 After completing the water supply,
(a)
inner lid
cover the laundry with
(C)
(C)
safety cover and close
the inner lid.
safety
cover
(b)
(b)
(In case of pump
drained washer)
Install the drain hose
5 Close the spin dryer lid.
about 70~80cm above
the ground for pump model.
0
CHANGING THE POSITION OF THE
DRAIN HOSE
6 Set the SPIN DRY
TIMER 2~3 minutes.
5
1
2
MOUNTING THE LEGS
Before attempting to change the position of the
4
Lay down the washer with its back facing
downward. Insert four legs into the leg mounting
sections of the base corners of the main body.
3
drain hose, disconnect the plug from the outlet.
1. Route the drain hose inside the machine.
2.Take out the drain hose from the opposite hole
and insert the drain hose into the hose holder.
SPIN DRY TIMER
Claw
Insert the claw of the
leg with the square
hole of the leg
Square
hole
2
1
mounting section,
and push the leg in
the arrow direction
2
1
as shown in the
Leg
Bottom face of
main body
figure until it clicks.
Hose holder
4
LAUNDRY GUIDE
MAINTENANCE
TROUBLE SHOOTING
TO LOAD THE LAUNDRY INTO
THE SPIN BASKET.
Press the laundry evenly and put the safety
cover into the spin basket as shown in the figure.
WASHING TIME
TROUBLE
CHECK POINT
WASHING
SELECTION
WASHING TIME
TYPE OF CLOTHING
The washing
machine does properly connected to a power
not work.
Check that the power cord is
10 to15 minutes
Extremely soiled
heavy fabric
outlet. Is there a power failure?
NORMAL
Clothes do
Is the machine overloaded?
not move freely.
8 to10 minutes
7 minutes
Linen, cotton, etc.
Is the laundry arranged
evenly?
Incomplete
spinning
Ordinary clothes
(underwear,etc)
Slightly soiled
synthetic fiber
Is the filter clogged with lint?
See cleaning of parts.
Incomplete
draining
2 to 5 minutes
SOFT
100% wool, mixed wool knitting,
thin synthetic fiber with
2 to 5 minutes
TO RETRIEVE THE CLOTHING THAT HAS
FALLEN BETWEEN THE BASKET AND TUB.
For safety reason, pull the power supply plug
out of the socket.
1. Unscrew the spin dryer hatch.
2. The spin dryer hatch is
Is the spin dryer lid closed
completely?
Are laundry items (socks, etc.) falling
out of the spin dryer basket and
clinging to the axle?
tags indicating hand washing
The spin dryer
basket will not
run.
SPIN DRY TIME
TYPE OF FABRIC
Thin (synthetic fiber)
TIME
1 min.
• See “To retrieve...”on page 5.
fixed to the brim by the
concave and convex
parts at two places.
Expand the concave and
wool
cotton
1~2 min.
3~5 min.
5 min.
AFTER OPERATION
1. Remove the power cord from the outlet.
2. Take out the laundry.
thick (cotton)
convex parts,and pull up
the spin dryer hatch to
3. Close the water tap and disconnect the water
supply hose.
DETERGENT
WATER
LEVEL
AMOUNT OF
DETERGENT
remove it.
3. Retrieve the clothing.
4. Close the spin dryer hatch. Push the hatch
firmly until the catch at the front is securely
attached.
4. Clean the washing machine.
- Periodical cleaning will extend the life of your
washing machine.
- Do not spray the unit water or use tinner, benzene,
alcohol etc, for cleaning it.
The amount of detergent
is average. Follow the
instruction printed on the
package for amount of
detergent. Choose the
amount of detergent
Low (37l)
37g
45g
54g
Medium(45l)
High (54l)
according to the fabric type.
DETERGENT
In case the water level is at “High”,
amount of water is 42l.
-H-
Follow the directions printed on the package
for amount of detergent. Choose the amount of
detergent depending on the fabric type and
water level.
CLEANING THE WASHING MACHINE
Wipe off stains on the cabinet and operation pane
with a soft cloth. Neither use benzene, thinner,
cleanser, or wax, nor scrub the washing machine
with a brush. Painted surfaces or plastic parts will
be damaged.
5
|