ATLANTIC
hot & cold
water dispenser
Hot water capacity:
5L/h at 85-95°C
Cold water capacity:
0.75L/h at 13-15°C
y
Removable
drip tray
Model:
30100
75 - 550
W
_IM.indd
1
1/28/2014 1:45:12 PM
tal surface away from direct sunlight and
sources of heat (stove, heater, radiator etc).
3.This table top water dispenser is not recom-
mended for outdoor use.
(at the rear).
• Now you are ready to use your Table Top Hot
and Cold Water dispenser.
4.NB: The water dispenser is pre-cleaned at
the factory but the reservoir and water lines
must be flushed with fresh water before us
as follows:
Instructions for cleaning:
• Unplug the dispenser from the power outlet.
• The dispenser was disinfected before leav-
ing the factory. You can use a fit for human
consumption disinfector to clean
• Keep the dispenser unplugged
• Fill the water tank with tap water full to ca-
pacity. Wait for 5 minutes until water settles.
• Proceed to drain the water from both faucets
until no more water is remaining.
• Proceed to make sure both drain caps and
faucets are closed.
• Place the water bottle on the water intake;
allow water to stand approximately
one minute.
• Open water faucets to ensure water flows
from both faucets.
it after six months.
• It is advisable to take it in for service after 1
year in order to clean the heating pot. This
must be done by a qualified technician.
• Care is needed when cleaning the appli-
ance to ensure that water do not go into the
electric power parts.
• Wash the inside of the reservoir with warm
water and baking soda solution. The solution
should be about 2 tablespoons of baking
soda to a quarter of water.
• Plug the dispenser into the electrical outlet.
• Turn the cold and hot water switches ON
• The drip tray and water faucets should be
cleaned with mild detergent and warm water.
Trouble shooting guide:
PROBLEM
SOLUTION
Dispenser does not work properly or water
does not flow out.
• Check if the appliance is plugged in
and switched on.
• Check if there’s water in the bottle
• Clear away any blockages in the reservoir.
• Check if the circuit break and see if not
tripped or a blow fuse.
Water is not hot enough
Water is not cold enough
• Check to see if hot water switch
is turned on.
• Too much hot water has been used in a
short period of time. Allow it a few minutes it
will heat up again.
• Check to see if cold water switch
is turned on.
• Too much cold water has been used in a
short period of time. Allow it a few minutes it
will heat up again.
Vibrations
Leakage
• Check to see that the water
dispenser is level.
• Check to see that the bottle is properly fitted
or change bottle if damaged.
_IM.indd
3
1/28/2014 1:45:12 PM
_IM.indd
4
1/28/2014 1:45:12 PM
|
Magnavox VCR VR400BMG User Manual
Makita Cordless Drill NHP1030 User Manual
Makita Cordless Sander LXOB01 User Manual
Mamp;S Systems Speaker 8 Ohm User Manual
Marantz Stereo Amplifier SM 11S1 User Manual
Marshall Amplification Stereo Amplifier Hand Crafted Amplifiers User Manual
Mazda Crib Toy 4112A NZLCTHL3 User Manual
MB QUART Car Speaker MBQ12SB4 User Manual
Metra Electronics Car Stereo System 95 7318 User Manual
MGE UPS Systems Power Supply 18 280 kVA User Manual